ACIM Personal Knowledgebase

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Cisco manual ======
 

( https://www.samuraj-cz.com/clanek/cisco-ios-1-uvod-prikaz-show/ ):

sh ? ( pringt every show commands ) 
sh run
show running config
show int des 
show interface description
sh ip int br
show ip interfaces brief
sh log
show logging
To changing coniguration: 
conf t ( configure terminal, to return Ctr + z )
Example change some interface:
int Gi2/0/14 ( some interface from show int des )
Before change print configuration interface :
Mainswitch#sh run int Gi2/0/14
Building configuration...

Current configuration : 318 bytes
!
interface GigabitEthernet2/0/14
 description BC10 Huawei MM2
 switchport access vlan 247
 switchport mode access
 no logging event link-status
 no snmp trap link-status
 storm-control broadcast level pps 200 150
 storm-control multicast level pps 100 80
 spanning-tree portfast
 spanning-tree bpduguard disable
end

After that for example change VLAN :

conf t ( enter configuration mode )
int Gi2/0/14 ( enter configuratio interface )
switchport access vlan 240 ( change VLAN access )
To change VLAN access to trunk
no  switchport access vlan 247 ( delete access mode conf ) 
no  switchport mode access     ( delete access mode conf ) 
switchport mode trunk


write ( save configuration )

ACIM Personal Knowledgebase

User Tools

Site Tools

Page Tools