ACIM Personal Knowledgebase

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Synchronize time with external NTP ======

Time synchronization is an important aspect for all computers on the network. By default, the clients computers get their time from a Domain Controller and the Domain Controller gets his time from the domain’s PDC Operation Master. Therefore the PDC must synchronize his time from an external source. I usually use the servers listed at the NTP Pool Project website. Before you begin, don’t forget to open the default UDP 123 port (in- and outbound) on your (corporate) firewall.

  - First, locate your PDC Server. Open the command prompt and type: C:>netdom /query fsmo
  - Log in to your PDC Server and open the command prompt.
  - Stop the W32Time service: C:>net stop w32time
  - Configure the external time sources, type: C:> w32tm /config /syncfromflags:manual /manualpeerlist:”0.pool.ntp.org, 1.pool.ntp.org, 2.pool.ntp.org”
  - Make your PDC a reliable time source for the clients. Type: C:>w32tm /config /reliable:yes
  - Start the w32time service: C:>net start w32time
  - The windows time service should begin synchronizing the time. You can check the external NTP servers in the time configuration by typing: C:>w32tm /query /configuration
  - Check the Event Viewer for any errors.
  - If you need manual synchronize to NTP server : C:>w32tm /config /update
Tested on Windows Server 2008 R2 (Build 7600).

ACIM Personal Knowledgebase

User Tools

Site Tools

Page Tools